Laser Cleaning Adelaide delivers precise, dry cleaning for turbines and generators—lifting oxides, corrosion, heat tint, coatings and hydrocarbon films from casings, frames, cooling fins and auxiliaries. No grit to enter windings, no chemicals to manage, and minimal masking around critical interfaces. Ideal for planned outages, condition monitoring and life-extension programs.
Zero grit near windings, bearings or seals—safer for machinery health.
Target flanges, fasteners, fins and gasket landings with minimal masking.
Remove fouling on metallic fins and housings to aid cooling efficiency.
Portable systems, clean sites and fast turnaround during outages.
Remove corrosion, heat tint and paint from turbine casings, generator frames and guards.
Lift fouling on metallic fins and ventilation paths to help restore cooling performance.
Precision clean sealing faces and threads for better fit-up and leak prevention.
Degrease housings and coupling guards—reduce fire and slip risks around maintenance zones.
Remove coatings and corrosion on lube, seal oil and cooling water skids and lines.
Clean around labels, sight glasses and markings without damage or abrasion.
Note: We avoid direct cleaning of electrical windings/insulation and slip-ring contact surfaces; localised cleaning of adjacent metallic structures is feasible following site assessment.
Casings, frames, pipework—corrosion, oxides and coatings removed.
Heat tint and surface films lifted without abrasives or pickling pastes.
Cooling fins, guards and housings—controlled cleaning to protect finish.
Localised cleaning on adjacent metallic structures; assessment recommended near electrical interfaces.
Selective touch-off around flanges/fasteners with extraction controls.
De-paint/prepare only where required—minimise masking and rework.
Avoid grit ingress and solvent handling near sensitive machinery.
Faster prep around flanges and studs reduces outage hours and rework.
Dry, precise process—cleaner decks and safer access during shutdowns.
Targets contamination, not base metal—preserves geometry and finish.
Prepare surfaces for NDT or recoat with uniform, repeatable results.
From spot cleaning to large surfaces—systems sized to your scope.
Define assets, materials, access and outage windows; optional pilot patch.
Parameters, extraction and SWMS/JSA aligned to site HSE and LOTO plans.
Localised or broad-area cleaning with minimal masking and clean work zones.
Before/after evidence, recoat/NDT readiness and punch-list close-out.
Working to outage milestones? Share your schedule and scope.
Ask our team for a turbine/generator method statement and outage-ready estimate.
Share asset type (steam/gas/wind turbine, generator), materials, area and access—we’ll confirm feasibility and a clear time-cost estimate.